|
Register | FAQ | Members List | Calendar | Mark Forums Read |
1999-2004 Saleen Mustang For the SN-95 New Edge platform. Be sure to specify year, model and equipment if asking for help. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
New to me Saleen and first mods
Okay guys so I recently picked up an 02 Saleen SC coupe #353, torch red running stock boost.
The engine shakes a good bit at idle and the gas mileage is pretty terrible. What does that seem like it could be? If I were to up the boost would I need to change out the injectors and fuel pump? Or anything else for that matter (MAF, TB,etc) Also the only mods are an O/R H pipe, bbk throttle body and a Roush shifter. What were some of your favorite mods that you have done? Thanks guys! |
#2
|
|||
|
|||
21 century intercooler, heat exchanger and an 03 cobra intercooler pump .. Ngk tr6 plugs , injectors and an svt focus fuel pump if you want to up the boost
|
#3
|
|||
|
|||
I would go through a standard tune-up and then go from there. (Plugs, tb cleaning, filters ~ air/fuel ~, etc...)
|
#4
|
||||
|
||||
Check engine light on? Unless the car has upgraded cams it should idle rough.
__________________
'03 S281 #0198 322HP 306TQ 4.6 WAP bored .030 over with DSS forged rotating assembly and billet main support*Comp 278AH Cams valve springs, retainers*6061 Plenum*FRPP 70mm TB*Victor Jr Intake*MSD Coils*JLT CAI*SCT SF3 *BBK Shorties and X*SLP PowerFlo CB*UPR FW adjuster and quadrant*FRPP 4:10's*Tri Ax*King Cobra clutch*Fidanza Alum Flywheel*Walbro 240lpm FP |
#5
|
||||
|
||||
Quote:
Where the heck is the modify post button on here?
__________________
'03 S281 #0198 322HP 306TQ 4.6 WAP bored .030 over with DSS forged rotating assembly and billet main support*Comp 278AH Cams valve springs, retainers*6061 Plenum*FRPP 70mm TB*Victor Jr Intake*MSD Coils*JLT CAI*SCT SF3 *BBK Shorties and X*SLP PowerFlo CB*UPR FW adjuster and quadrant*FRPP 4:10's*Tri Ax*King Cobra clutch*Fidanza Alum Flywheel*Walbro 240lpm FP |
#6
|
|||
|
|||
Quote:
least noticeable mod: the lower control arms. can't say i felt that much of a difference.
__________________
07 Porsche 911 Turbo 02 Saleen S/C Speedster 3.73 gears Chicane 66mm Pulley SCT custom tune SVT Focus Fuel Pump 13" Brembo Brakes LFP Heat Exchanger and Supertank TorkTech Intake SVT Cobra single blade TB Chicane Intercooler 42lb injectors 90mm MAF FPRP Aluminum Driveshaft Maximum Motorsports LCA's, Subframes, Torque Arm, Panhard Bar, Steering Shaft, Front Control Arms and Aluminum Rack Bushings MM Coilover kit with caster camber plates |
#7
|
||||
|
||||
You bought this car in Louisiana? I know the guy you got it from. I can ask what issues he had.
__________________
'03 S281 #0198 322HP 306TQ 4.6 WAP bored .030 over with DSS forged rotating assembly and billet main support*Comp 278AH Cams valve springs, retainers*6061 Plenum*FRPP 70mm TB*Victor Jr Intake*MSD Coils*JLT CAI*SCT SF3 *BBK Shorties and X*SLP PowerFlo CB*UPR FW adjuster and quadrant*FRPP 4:10's*Tri Ax*King Cobra clutch*Fidanza Alum Flywheel*Walbro 240lpm FP |
#8
|
|||
|
|||
I actually bought it from a dealer that bought it from a dealer that bought it from him haha but yeah I talked to him when I first looked at it and he's been really helpful with the whole ordeal and it turned out to be that my stepdad put low grade gas in it-_-
|
#9
|
||||
|
||||
That will do it. My son did that one time and I got a nasty detonation. These engine hate detonation. Sure way to mess one up.
__________________
'03 S281 #0198 322HP 306TQ 4.6 WAP bored .030 over with DSS forged rotating assembly and billet main support*Comp 278AH Cams valve springs, retainers*6061 Plenum*FRPP 70mm TB*Victor Jr Intake*MSD Coils*JLT CAI*SCT SF3 *BBK Shorties and X*SLP PowerFlo CB*UPR FW adjuster and quadrant*FRPP 4:10's*Tri Ax*King Cobra clutch*Fidanza Alum Flywheel*Walbro 240lpm FP |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|