View Single Post
  #8  
Old 05-10-2021
02saleen's Avatar
02saleen 02saleen is offline
Senior Saleen Forums Participant
 
Join Date: Sep 2008
Location: CA
Posts: 239
Default

Finally go the rear seats back from the upholstery shop since they were form a convertible and had to be modified to fit my coupe. I must say I do like the new look.

However, I have a few questions.
  • Does the driver seat seem to be higher and further back than the OEM ford seat? I played with the settings and put it as low and forward as possible and still seems further back and higher than the OEM one from Ford.
  • I might need to take the driver seat to get re-welded as I feel it lifting a little from the rails if I lean back. I assume this isn’t normal
  • Also, the seat controls assembly seems to be a little flimsy. Will some simple apoxy do the trick?

Wondering what others have done to try and to it right the first time with some of these potential fixes.
Attached Thumbnails
20210509_152724.jpg  


Last edited by 02saleen; 07-09-2021 at 12:51 PM.
Reply With Quote