The Saleen Forums at soec.org

The Saleen Forums at soec.org (https://saleenforums.soec.org/index.php)
-   2005-2009 Saleen Mustang (https://saleenforums.soec.org/forumdisplay.php?f=74)
-   -   Saleen Supershaker TMAP Sensor Wiring (https://saleenforums.soec.org/showthread.php?t=23071)

jrcalvin 01-08-2021 03:56 PM

Saleen Supershaker TMAP Sensor Wiring
 
A question for Saleen Supershaker owners.

The TMAP sensor is a 4 pin sensor. The Saleen Supershaker Instruction Manual says 5 pin but the TMAP Sensor is actually a 4 pin sensor.

1. The original Supershaker TMAP sensor part number is 2R3A-9F479-AA. Is there a superseded part number if I need to replace the TMAP sensor? Yes, I can also check with the Ford dealer.

2. The 4 pin TMAP sensor utilizes only the two wires, the grey wire and the grey w/red stripe wire in the TMAP sensor female connector/pigtail. The two brown wires in the female connector are not used but are tucked into the plastic convolute.
Question. Which of the 4 pins in the TMAP sensor is the designated pin for the grey wire and which is the designated pin for the grey/red stripe wire?

Orientation should be noted with the TMAP sensor installed on the Supershaker flat plate. For example; aft pin, fwd pin etc.

If I had the original TMAP sensor and female connector I would not need to ask this basic Supershaker wiring question.

tbar 01-08-2021 07:57 PM

Took a look at mine, 1st pin is grey red, 2nd pin is grey. Going from front of the engine to back.

jrcalvin 01-09-2021 02:36 PM

Supershaker TMAP wiring
 
Thank you Tbar for taking the time to check out the wiring. I recently acquired a used Supershaker Kit and the Kit had the TMAP sensor installed but did not have the female Connector for the TMAP sensor so the grey and grey/red wires location to the TMAP were an unknown.

tbar 01-09-2021 07:41 PM

No problem.


All times are GMT -4. The time now is 05:02 AM.